Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
camera shake
#1
I'm having a few problems with long exposures. I always get camera shake. I am using a wireless remote, mirror lock is on and it's a pretty sturdy tripod and yet I get camera shake and very blurred images. I've tried everything I can to ensure there's no camera shake and yet I still get blurred shots when I try macro photography.
Camera is Canon 70D and lens Tamron 90mm macro.
I've had to resort to doing everything via flash or with very wide apertures handheld.
Any suggestions?
Thanks
Reply

#2
Do you switch off Auto Focus?
Ask yourself, "What's most important for the final image?".
Reply
#3
Richard, is your Tamron lens the Di VC version? If so, the VC must be switched off when the camera is tripod mounted.
GrahamS
Take my advice.  I'm not using it.Wink

Reply
#4
Have you tried taking a series of photographs, on the tripod, from handheld speeds to long exposures? If so, when does the blur kick in?
With really long exposures, a bit of movement as the shutter opens and closes should not be too much of an issue, as the amount of light admitted at these brief moments should barely register on the image. That is why I am wondering if the Auto Focus is hunting, or even just vibrating, during the long exposures.
Ask yourself, "What's most important for the final image?".
Reply
#5
(Sep 21, 2016, 08:19)GrahamS Wrote: Richard, is your Tamron lens the Di VC version? If so, the VC must be switched off when the camera is tripod mounted.
I wondered that too, but it is not a lens I am familiar with.
Ask yourself, "What's most important for the final image?".
Reply
#6
I actually have both versions of that lens - will be selling the older one.
I've tried it with the vibration control off and on. Same problem. It's not a focus problem, though the lens is set to manual focus. So it's not hunting during the exposure.
I will try the different exposure lengths and get back to you.
Thanks for all the suggestions.
Richard
Reply

#7
Richard - you write that you have done everything you can to eliminate camera shake, and that you have tried VC both on and off, but you still get "very blurred images". There would appear to be nothing else left to cause that effect other than either relative movement between the subject and the camera during exposure or a lens focusing issue. Considering the latter, is the camera pointing downwards over the subject - and if so, could the focusing mechanism in the lens be drifting due to gravity?

Cheers.
Philip
Reply
#8
Good point Philip.

You say you have two lenses. Does it do it with them both?
Ask yourself, "What's most important for the final image?".
Reply
#9
Is the "blur" directional = camera movement, or is it omnidirectional = focus?

What software are you using to view the images? Does the blur appear if you view the images in all environments i.e. in an image viewer and in editing software?
GrahamS
Take my advice.  I'm not using it.Wink

Reply
#10
I have the older version of that lens and it's a stunner. Have you tried it a non macro shot? When focussed really close the slightest movement can show up.
Reply
#11
Hi Richard,
Are your macro shots indoor or outdoor?
The slightest air movement would send the shot out of focus. In my opinion, an outdoor macro shot with long exposure would be very difficult, if not impossible.
If this is where the problem stems from, then the experts on the site may be able to assist.
It may help if you could post an image with exif data.
Cheers,
Mike.
" Your first 10,000 photographs are your worst "
Henri Cartier - Bresson.
Reply

#12
Some modern buildings shake much more than you might think.

Are you inside and off the ground floor? A tripod is a rigid connection to the building, while hand held puts you in the system to damp things.
Reply
#13
Define, Long Exposure. Ed.
To each his own!
Reply
#14
I thank you for all the suggestions. I knew I came to the right place for advice!
And I finally nailed the problem! WDHewson came closest to the answer. I live in an older apartment building and buried somewhere in the plumbing is an airlock. With all the pipes banging , even though I can't hear it, and probably some of the other sources of vibration like the elevators and washing machines, t with all that the floor is vibrating quite a bit, though I have never felt it. Took pictures at 3am when everyone is in bed and they are nice and sharp. Guess I'm going to have a few late nights!
Thanks again to everyone for all the suggestions.
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  What Camera?? (Thread Two) Barbara G. 75 55,456 Jul 13, 2019, 00:29
Last Post: jogesh12345
  Camera Bag Review- PhotoCross by MindShift Gear admin 3 2,766 Jul 8, 2019, 05:40
Last Post: jogesh12345
  DSLR Camera Focusing Tips for Beginners Jeffbridge 1 3,300 Jul 5, 2019, 01:23
Last Post: jogesh12345

Forum Jump:


Users browsing this thread: 1 Guest(s)